Cisco Cisco TelePresence MX700 Veröffentlichungshinweis
New features and functionality in TC5.1.0
Cisco TelePresence System C/EX/SX/MX Series Software Release Notes
Page 148 of 194
Improved GUI
An ‘Extend Meeting’ message will now be displayed on the OSD as well as on the Cisco Touch, when
the system has been scheduled using TMS or CTSman, and the system is paired with a Cisco Touch.
Previously the message would only appear on the Cisco Touch.
the system has been scheduled using TMS or CTSman, and the system is paired with a Cisco Touch.
Previously the message would only appear on the Cisco Touch.
An informational message will now be displayed on the OSD (On Screen Display) after a successful
software upgrade or factory reset to indicate success of failure.
software upgrade or factory reset to indicate success of failure.
WebSnapshots for remote sites
When WebSnapshots is enabled and encryption is not active (in a call) you will now in addition to get
local snapshots, also be able to see snapshots of the remote incoming video.
local snapshots, also be able to see snapshots of the remote incoming video.
Web interface enhancements
The information in the Maintenance tab has been updated to include:
What software versions the system currently has valid release keys for.
Informational text explaining the Upgrade Software, Add Release Key and Add Option Key
options.
The system can now be reset to factory default settings from the Maintenance tab.
Serviceability enhancements
The following serviceability enhancements have been included in this release:
Maintenance shell
If the system detects a situation where it is not possible to run the main application it will reboot, if the
reboot is unsuccessful the system will go into a ‘maintenance mode’. In this mode the following will
apply:
reboot is unsuccessful the system will go into a ‘maintenance mode’. In this mode the following will
apply:
! The system will boot up without starting the main application, hence there will be no video output
or GUI on the screen.
! In this mode it will be possible to connect to the system over a serial connection or SSH (IP) to
access a reduced API, which can be used for faultfinding. In this mode the following commands
are available: ‘factoryreset’, ‘selectsw’, ‘reboot’, ‘version’, ‘pkgverify’, ‘help’ and ‘log’.
are available: ‘factoryreset’, ‘selectsw’, ‘reboot’, ‘version’, ‘pkgverify’, ‘help’ and ‘log’.
Harmonized factory reset
In TC5.1 the following method will be used to factory default the systems:
! EX60/EX90/SX20/C20:
When the unit is off, press and hold the power button
Wait until the power LED goes dark and then light up again (approximately 10 seconds).
Release the power button and press it twice.
The system will boot up and display a confirmation message on the video screen if the
process was successful.
! MX200/MX300
Press the small reset button for approximately 5 seconds after switching power on, and then
release it.
The system will boot up and display a confirmation message on the video screen if the
process was successful.