Cisco Cisco Aironet 1240 AG Access Point
19
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(7)JA1
OL-8206-01
Caveats
•
CSCej08390—Reboot loop with snmp-server ifindex persist configured no longer occurs.
•
CSCsb85705—RX byte counter per rate now increments correctly.
•
CSCeg83274—Access point now sends RADIUS state information.
•
CSCsb49385—A roaming workgroup bridge no longer selects a non-optimal root access point.
•
CSCsb56012—Clients are now able to associate when WDS device is down.
•
CSCef77951—Excessive processor memory is no longer held by IRB/CRB rxtypes.
•
CSCsb84048—QBSS functions the same for Cisco Airespace and LWAPP-enabled Cisco Aironet
access points.
access points.
•
CSCee36192—The no snmp-server enable traps tty command is effective through reload.
Resolved Caveats in Cisco IOS Release 12.3(7)JA
These caveats are resolved in Cisco IOS Release 12.3(7)JA:
•
CSCeh43628—1230 series access point no longer exhibits DHCP failure when client is configured
for mixed mode (CKIP and 128-key WEP).
for mixed mode (CKIP and 128-key WEP).
•
CSCeh49024—Memory leak no longer occurs when an invalid layer 3 WLCCP packet is received.
•
CSCsa42443—Autoinstall program now uses hostname from DHCP (if present) when access point
is booted with factory defaults.
is booted with factory defaults.
•
CSCsa66924—Access point no longer crashes and reboots when policy-map command is issued.
•
CSCsa71255—Logging snmp-trap no longer returns to default after reboot.
•
CSCeh26214—IP RADIUS source interface no longer disappears after reboot.
•
CSCsb06824—Open authentication is no longer added to an EAP SSID when the configuration is
loaded.
loaded.
•
CSCei07867—RM22A radio output power for different channels has been documented in the
appropriate hardware installation guides.
appropriate hardware installation guides.
•
CSCsa73846 (duplicate of CSCed16920)—350 series access point no longer shows high CPU and
TTY background tracebacks.
TTY background tracebacks.
•
CSCsa78495—LRS configured 1200 series access point now updates unknown username count.
•
CSCsa88841—DFS-IAPP constant has been changed to 0x34.
•
CSCsb09778 (duplicate of CSCsb06218)—1130 and 1200 access point boot loaders now boot IOS
when environment variables are deleted from flash.
when environment variables are deleted from flash.
•
CSCsb27662—Reports greater than 7900 bytes are no longer dropped by WLSE at RM AGG.
•
CSCsb06236—CCKM repeater no longer hangs during access point radio scan.
•
CSCsa90752—Trunking no longer fails on an 1100 series access point when in workgroup bridge
mode.
mode.
•
CSCeh97288 (duplicate of CSCsa79281)—Spectralink phones no longer reboot after upgrading to
Cisco IOS Release 12.3(4)JA
Cisco IOS Release 12.3(4)JA
•
CSCsb11227—1130 series access points operating as a WDS no longer run out of memory.
•
CSCsb14224—Reverse ARP functions on all VLANs
•
CSCeb52431—The 1100 series access point no longer sends hundreds of additional authentication
requests to a TACACS+ server after successful authentication.
requests to a TACACS+ server after successful authentication.