Cisco Cisco 521 Wireless Express Access Point Installationsanleitung

Quick Start Guide: Cisco 521 Wireless Express Access Point

Follow these steps to mount your access point on a suspended ceiling:

Step 1

Determine the location on the ceiling where you intend to mount the
access point.

Step 2

Select the appropriate T-rail clip for your suspended ceiling and
open the clip to the maximum.

Step 3

Place the clip over the T-rail and close it to the appropriate (A, B,
or C) detent.

Step 4

Tighten the two T-rail locking screws to prevent the clip from
sliding along the rail.

Step 5

Observe the T-rail width detent letter (A, B, or C) that corresponds
to the T-rail width.

Step 6

Align the corresponding (A, B, or C) holes on the mounting plate
over the T-rail mounting plate holes.

Step 7

Hold the mounting plate and insert a 6 x 32 x 1/4 in. flat head screw
into each of the four corresponding (A, B or C) holes and tighten.

Step 8

If needed, drill or cut a cable access hole large enough for the access
point cables and pull the cables through the hole until you have
about 1 ft. of exposed cables protruding from the hole.

Step 9

Attach the access point to the mounting plate.