Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch Installationsanleitung

• Unusually long access time: 

Due to the spanning tree loop detection logic, adding new connections 
might take 30 to 60 seconds for the affected interfaces and/or LAN to 
become operational.

This section describes the exterior of the smart switches including ports, 
LEDs, and connections.

The Ethernet ports are located on the back panel of the switch.

RJ-45 Ethernet Ports—Use these ports to connect network devices, such 
as computers, printers, and access points, to the switch. If your switch 
supports PoE, ports 1-4 can provide PoE and ports 5-8 are standard 
Ethernet ports.

The LEDs are located on the front of the switch.

System LED—(Green) Lights steady when the switch is powered on, and 
flashes when booting, performing self tests, and acquiring an IP address. If 
the LED flashes amber, the switch has detected a hardware failure.

LINK/ACT LED—(Green) Lights steady when a link between the 
corresponding port and another device is detected. Flashes when the port 
is passing traffic. 

Power—The Power port is where you will connect the switch to power.

The 8-Port Smart Switch models does not have a Reset button. To return 
the device to factory default settings, follow the instructions in the Cisco 
Small Business Smart Switch Administration Guide.