Cisco Cisco Packet Data Gateway (PDG) Documentation Roadmaps

Seite von 982
  Packet Data Interworking Function Overview 
Features and Functionality - Base Software  ▀   
Cisco ASR 5000 Series Product Overview  ▄  
 
  OL-22938-01 
 
If neither 
 nor 
 is configured, sessions are sorted 
based on the idle-timer, and sessions with a longer idle-timer are deleted first. 
 
SCTP (Stream Control Transmission Protocol) Support 
PDIF provides support for SCTP (Stream Control Transmission Protocol) for use in communicating with Diameter 
peers over IPv6. 
Diameter/SCTP connections are set up for administratively enabled Diameter peers whenever the system configuration 
is loaded. In the event of certain card or task-level failures, SCTP connections are torn down and re-established (but 
note that the Diameter state will still be maintained). 
SCTP complies with the description in [RFC 2960 Section 5.1.1] for how to handle the case where the peer is incapable 
of supporting all of the outbound streams that the endpoint wants to configure. Specifically, PDIF does not abort the 
session but instead adjusts the association's number of outbound streams to match the number of inbound streams 
advertised by the peer (in the event that the number sent is less). 
 
X.509 Digital Trusted Certificate Support 
A digital certificate is an electronic credit card that establishes one's credentials when doing business or other 
transactions on the Web. Some digital certificates conform to ITU-T standard X.509 for a Public Key Infrastructure 
(PKI) and Privilege Management Infrastructure (PMI). X.509 specifies, among other things, standard formats for public 
key certificates, certificate revocation lists, attribute certificates, and a certification path validation algorithm. 
 
The PDIF generates an SNMP notification when the certificate is within 30 days of expiration and approximately once a 
day until a new certificate is provided. The operator needs to generate a new certificate and then configure the new 
certificate using the CLI. The certificate is then used for all new sessions. 
Important:
  For more configuration information, refer to Global Configuration in the Command Line Interface 
Reference. 
 
Custom DNS Handling 
By default, the PDIF always returns a DNS address in the CP payload if one is received from the configuration or the 
HA. A new CLI has been added defining an alternate series of supported behaviors depending on the number of 
INTERNAL_IP4_DNS. These include, but are not limited to, the following: 
 
 
Provides a mechanism whereby the DNS address present in configurations will be sent to the MS in the CP 
payload only if the MS requests one. 
 
The address 0.0.0.0 is treated as invalid and not included.