Cisco Cisco Packet Data Gateway (PDG) Documentation Roadmaps
ASR 5000 Hardware Platform Overview
▀ ASR 5000 Line Cards
▄ Cisco ASR 5000 Series Product Overview
OL-22938-01
Number
Description
4
Optical Gigabit Ethernet Management LAN Interfaces—Two Small Form-factor Pluggable (SFP) optical Gigabit
Ethernet interfaces to connect optical transceivers.
Ethernet interfaces to connect optical transceivers.
5
10/100/1000 Mbps Ethernet Management LAN Interfaces—Two RJ-45 interfaces, supporting 10/100 Mbps or 1
Gbps Ethernet.
Gbps Ethernet.
6
Console Port—RJ-45 interface used for local connectivity to the command line interface (CLI). See Cabling the Switch
Processor Input/Output Line Card for more information.
Processor Input/Output Line Card for more information.
7
BITS Timing Interface—Either a BNC interface or 3-pin wire wrap connector. Used for application services that use
either the optical or channelized line cards.
either the optical or channelized line cards.
8
CO Alarm Interface—Dry contact relay switches, allowing connectivity to central office, rack, or cabinet alarms. See
the Applying Power and Verifying Installation for more information.
the Applying Power and Verifying Installation for more information.
Management LAN Interfaces
SPIO management LAN interfaces connect the system to the carrier‘s management network and subsequent
applications, normally located remotely in a Network Operations Center (NOC). You can use the RJ-45 10/100/1000
Mbps Ethernet interfaces or optical SFP Gigabit Ethernet interfaces.
applications, normally located remotely in a Network Operations Center (NOC). You can use the RJ-45 10/100/1000
Mbps Ethernet interfaces or optical SFP Gigabit Ethernet interfaces.
When using the RJ-45 interfaces, CAT5 shielded twisted pair cabling is recommended.
Important:
Use shielded cabling whenever possible to further protect the chassis and its installed components
from ESD or other transient voltage damage.
Table 12. SFP Interface Supported Cable Types
Module Type
Card
Identification
Identification
Interface Type
Cable Specifications
1000Base-
SX
SX
Ethernet 1000
SX
SX
Fiber, LC duplex female
connector
connector
Fiber Type: Multi-mode fiber (MMF), 850 nm
wavelength
Core Size (microns)/Range:
wavelength
Core Size (microns)/Range:
62.5/902.23 feet (275 meters)
50/1640.42 feet (500 meters)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -17 dBm
Rx Sensitivity: -17 dBm
Console Port
The console uses an RS-232 serial communications port to provide local management access to the command line
interface (CLI). A 9-pin-to-RJ-45 console cable is supplied with each SPIO card. The console cable must provide
carrier-detect when attached in a null modem configuration.
interface (CLI). A 9-pin-to-RJ-45 console cable is supplied with each SPIO card. The console cable must provide
carrier-detect when attached in a null modem configuration.