Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Context Configuration Mode Commands
▀ threshold pdsn-service init-rrq-rcvd-rate
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
threshold pdsn-service init-rrq-rcvd-rate
Set an alarm or alert based on the average number of calls setup per second for a PDSN service.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Deletes the alert or alarm.
Default: 0
The high threshold average number of calls setup per second must be met or exceeded within the polling
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 1000000.
The high threshold average number of calls setup per second must be met or exceeded within the polling
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 1000000.
Default:0
The low threshold average number of calls setup per second that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 1000000.
The low threshold average number of calls setup per second that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 1000000.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Use this command to set an alert or an alarm when the average number of calls setup per second is equal to or
less than a specified number of calls per second.
Alerts or alarms are triggered for the number of calls setup per second based on the following rules:
less than a specified number of calls per second.
Alerts or alarms are triggered for the number of calls setup per second based on the following rules:
Enter condition: Actual number of calls setup per second > High Threshold
Clear condition: Actual number of calls setup per second £ Low Threshold
Example
The following command configures a number of calls setup per second threshold of 1000 and a low threshold of 500 for
a system using the Alarm thresholding model:
The following command configures a number of calls setup per second threshold of 1000 and a low threshold of 500 for
a system using the Alarm thresholding model: