Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Ethernet Interface Configuration Mode Commands
ipv6 access-group ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
ipv6 access-group
Specifies the name of the ACL group to assign the interface to. You can filter for either inbound or outbound traffic.
Product
PDSN, HA
Privilege
Security Administrator, Administrator
Syntax
Removes a previously configured access group association.
Specifies the name of the access group. group_name must be an alpha and/or numeric string of 1 to 79
characters.
characters.
Applies the filter to the inbound traffic.
Specify a priority_value for the access group from 0 to 4294967295. The lower values indicate a higher
priority.
Specify a priority_value for the access group from 0 to 4294967295. The lower values indicate a higher
priority.
Applies the filter to the outbound traffic.
Specify a priority-value for the access group from 0 to 4294967295. The lower values indicate a higher
priority.
Specify a priority-value for the access group from 0 to 4294967295. The lower values indicate a higher
priority.
Default: 0
Specifies the priority of the access group. 0 is the highest priority. If priority-value is not specified the priority
is set to 0. priority-value must be a value from 0 to 4294967295.
If access groups in the list have the same priority, the last one entered is used first.
Specifies the priority of the access group. 0 is the highest priority. If priority-value is not specified the priority
is set to 0. priority-value must be a value from 0 to 4294967295.
If access groups in the list have the same priority, the last one entered is used first.
Usage
Use this command to specify the ACL group to assign the interface to. Specify an ACL group name with this
command.
command.
Important:
Up to 8 ACLs can be applied to a group provided that the number of rules configured within the
ACL(s) does not exceed the 128 rule limit for the interface.
Example