Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Active Charging Service Configuration Mode Commands
▀ p2p-dynamic-rules
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
p2p-dynamic-rules
This command enables/disables the P2P Dynamic Signature Updates feature, and loads the P2P signature file from the
default or specified location into memory, optionally signatures for specific protocol(s) can be specified to be loaded.
default or specified location into memory, optionally signatures for specific protocol(s) can be specified to be loaded.
Important:
This release supports dynamic updates of signatures (detection logic) only for the following
protocols: Bittorrent, DirectConnect, eDonkey, Gnutella, Skype, and Yahoo.
Product
P2P
Privilege
Security Administrator, Administrator
Syntax
Enables the P2P Dynamic Signature Updates feature, and if available, loads the P2P signature file from the
default location: /usr/lib/p2p-rules.xml.
default location: /usr/lib/p2p-rules.xml.
Disables the P2P Dynamic Signature Updates feature, also any/specified signature(s) already loaded in the
memory is unloaded.
If there are any active sessions using the file, it changes the file status to inactive. And, when the sessions are
cleared, the file is removed from the memory.
memory is unloaded.
If there are any active sessions using the file, it changes the file status to inactive. And, when the sessions are
cleared, the file is removed from the memory.
Specifies that the P2P signature file at the specified location (other than the default location) be loaded into
memory and applied.
memory and applied.
specifies the file‘s location, and must be one of the following:
[file:]{/flash | /pcmcia1 | /hd-raid}[/directory]/
Specifies to force load the specified file into memory and apply it, even if it is obsolete.
By default, when a signature file is loaded from a specified location
By default, when a signature file is loaded from a specified location
, while loading, it is
compared with the file at the default location. The newer file of the two files is loaded into memory. To
override this behavior, use the
override this behavior, use the
keyword.