Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
PDG Service Configuration Mode Commands
bind ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
bind
Binds the PDG service IPv4 address to a crypto template and specifies the maximum number of sessions the PDG
service supports.
service supports.
Product
PDG/TTG
Privilege
Security Administrator, Administrator
Syntax
Removes a previously configured binding.
Specifies the IPv4 address of the PDG service with which the UE attempts to establish an IKEv2/IPSec
tunnel. This address must be a valid IP address within the context.
This is a mandatory parameter.
tunnel. This address must be a valid IP address within the context.
This is a mandatory parameter.
Specifies the name of the crypto template to be bound to the PDG service. This is the name of the IPSec
policy to be used as a template for PDG/TTG subscriber session IPSec policies. The crypto template includes
most of the IPSec and IKEv2 parameters for keepalive, lifetime, NAT-T, and cryptographic and
authentication algorithms. There must be one crypto template per PDG service.
This is a mandatory parameter.
policy to be used as a template for PDG/TTG subscriber session IPSec policies. The crypto template includes
most of the IPSec and IKEv2 parameters for keepalive, lifetime, NAT-T, and cryptographic and
authentication algorithms. There must be one crypto template per PDG service.
This is a mandatory parameter.
is any value from 0 - 127 alpha and/or numeric characters.
Default: There is no default value.
Specifies whether the PDG service provides TTG or PDG functionality, as follows:
Specifies whether the PDG service provides TTG or PDG functionality, as follows:
In TTG mode, PDN connectivity is provided through the GGSN. PDG functionality is provided by the
combined TTG and GGSN.
In PDG mode, PDN connectivity and PDG functionality are provided directly through the PDG service.
This is a mandatory parameter.
Important:
PDG mode is not supported in this software release.
Dependencies:
When you configure the PDG service to be in TTG mode, you must also configure the SGTP service using
the
When you configure the PDG service to be in TTG mode, you must also configure the SGTP service using
the
command, as the TTG needs to connect with the GGSN to complete the
PDG functionality.