Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
PDSN Service Configuration Mode Commands
spi zone ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
spi zone
Configures the security parameter index (SPI) between the PDSN service and the PCF with mapping between a zone
number to a set of PDSNs per PDSN service to redirect call on the basis of PCF zone.
number to a set of PDSNs per PDSN service to redirect call on the basis of PCF zone.
Product
PDSN
Privilege
Security Administrator, Administrator
Syntax
Default: 60
Specifies the different PCF zones to configure in PDSN service. Mapping of a zone-number to a set of
PDSNs can be done per PDSN service basis.
zone_id must be an integer value between 1 and 32. A maximum of 32 PCF zones can be configured for a
PDSN service.
Specifies the different PCF zones to configure in PDSN service. Mapping of a zone-number to a set of
PDSNs can be done per PDSN service basis.
zone_id must be an integer value between 1 and 32. A maximum of 32 PCF zones can be configured for a
PDSN service.
Usage
An SPI is a security mechanism configured and shared by the PCF and the PDSN service. Please refer to IOS
4.1 and RFC 2002 for additional information.
Multiple SPIs can be configured if the PDSN service is communicating with multiple PCFs.
This PCF zone option is used for call redirection on the basis of PCF zone. When a new call arrives the
PDSN, it checks whether the PCF, from which the call arrived, belongs to a particular zone. If
4.1 and RFC 2002 for additional information.
Multiple SPIs can be configured if the PDSN service is communicating with multiple PCFs.
This PCF zone option is used for call redirection on the basis of PCF zone. When a new call arrives the
PDSN, it checks whether the PCF, from which the call arrived, belongs to a particular zone. If
Important:
The SPI configuration on the PCF must match the SPI configuration for the PDSN service on the
system in order for the two devices to communicate properly.
Use the
version of this command to delete a previously configured SPI.
Example
The following command configures the PDSN service to use an SPI of 256 when communicating with a PCF with the
IP address 192.168.0.2. The key that would be shared between the PCF and the PDSN service is q397F65.
The following command configures the PDSN service to use an SPI of 256 when communicating with a PCF with the
IP address 192.168.0.2. The key that would be shared between the PCF and the PDSN service is q397F65.
The following command deletes the configured SPI of
for an PCF with an IP address of
: