Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
RoHC Profile Decompression Configuration Mode Commands
crc-errors-so ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
crc-errors-so
This command sets the limits for when a NACK message is sent when in the SO (Second Order) state. A NACK is sent
when out of a specified number of packets a specified number of them have CRC errors.
when out of a specified number of packets a specified number of them have CRC errors.
Product
HSGW, PDSN
Privilege
Administrator
Syntax
Returns the command to its default value.
Default: 1
The number of received packets within a specified number of received packets that triggers the sending of a
NACK.
The number of received packets within a specified number of received packets that triggers the sending of a
NACK.
must be an integer from 0 through 10.
Important:
must be less than or equal to the value specified with the crc-errors-so-n command.
Default: 1
The number of packets to check for CRC errors.
The number of packets to check for CRC errors.
must be an integer from 1 through 10.
Usage
Use this command to set the parameters that trigger sending a NACK message when in the SO state.
Example
To configure a NACK to be sent when 4 out of the last 10 packets have CRC errors when in the SO state, use the
following commands:
To configure a NACK to be sent when 4 out of the last 10 packets have CRC errors when in the SO state, use the
following commands: