Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
SGSN Service Configuration Mode Commands
▀ ran-protocol
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
ran-protocol
This command specifies the IuPS service for the SGSN service to use for communication with the RAN.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Removes the IuPS service information from the SGSN service configuration.
Specifies the name of an IuPS service already configured on the system.
: Enter an alphanumeric string of 1 to 63 characters.
: Enter the name of the IuPS context, an alphanumeric string of 1 to 63 characters.
Usage
Use this command to configure the IuPS service context that the current SGSN service will use to
communicate with the RAN. Up to 8 definitions can be defined for a single SGSN service to allow for
multiple PLMNs support.
communicate with the RAN. Up to 8 definitions can be defined for a single SGSN service to allow for
multiple PLMNs support.
Example
The following command configures the SGSN service to use an IuPS service named iups1 that has been configured. in
the same context as the SGSN service:
The following command configures the SGSN service to use an IuPS service named iups1 that has been configured. in
the same context as the SGSN service: