Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Gateway Service Configuration Mode Commands
bs-monitor ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
bs-monitor
This command provides the configurations to enable or disable the ASN base station monitoring and related parameters
in a WiMAX ASN.
in a WiMAX ASN.
Product
ASN GW
Privilege
Administrator
Syntax
Disables the configured BS monitoring parameters.
Removes the configured BS monitoring feature and parameters.
Default: 60
Configures the interval duration in seconds between two ICMP ping messages sent to ASN BS for BS
monitoring.
Configures the interval duration in seconds between two ICMP ping messages sent to ASN BS for BS
monitoring.
specifies the amount of time in seconds between two ICMP ping message to monitor an ASN BS
and must be an integer value in the range of 1 through 36000.
Default: 5
Configures the number of retries before marking specific ASN BS as down/dead.
Configures the number of retries before marking specific ASN BS as down/dead.
specifies the number of retries to sent ICMP ping messages to an ASN BS before the ASN BS is
declared as dead/unreachable and must be an integer value in the range of 0 through 100.
Default: 3
Configures the timeout duration to wait for a response from ASN BS of ICMP ping message before
retransmitting the ICMP ping packets.
Configures the timeout duration to wait for a response from ASN BS of ICMP ping message before
retransmitting the ICMP ping packets.
must be an integer value in the range of 1 through 10.
Usage
Use this command to enable or disable the base station monitoring and to configure the ASN BS monitoring
parameters in a WiMAX ASN.
parameters in a WiMAX ASN.