Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Paging Controller Configuration Mode Commands
▀ retransmission-timeout
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
retransmission-timeout
Configures the amount of time that must pass without any response before the system re-attempts to send R6 control
packets to BS.
packets to BS.
Product
ASN PC-LR
Privilege
Administrator
Syntax
Sets the timeout duration to 3 seconds for retransmission of R6 control packets.
Disables/removes the configured timeout duration for retransmission of R6 control packets.
Default: 3
Specifies the maximum allowable time for the ASN paging controller service to wait for a response from the
BS before it a) attempts to communicate with the BS again (if the system is configured to retry the BS) or b)
marks the BS as unreachable.
Specifies the maximum allowable time for the ASN paging controller service to wait for a response from the
BS before it a) attempts to communicate with the BS again (if the system is configured to retry the BS) or b)
marks the BS as unreachable.
is measured in seconds and can be configured to any integer value between 1 and 1,000.
Usage
Use this command in conjunction with the
command in order to configure the
ASN paging controller services behavior when it does not receive a response from a particular BS.
Use the
Use the
command to delete a previously configured timeout value. If
after deleting the lifetime setting you desire to return the lifetime parameter to its default setting, use the
command.
The chassis is shipped from the factory with the retransmission timeout set to 3 seconds.
Example
The following command configures a retransmission timeout value of 5 seconds:
The following command configures a retransmission timeout value of 5 seconds:
The following command deletes a previously configured retransmission-timeout setting: