Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Gateway Service Configuration Mode Commands
▀ active-relay
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
active-relay
Use this command to enable the active relay of R4 and R6 messages in ASN GW, and to configure the timeout duration
in seconds for the R4 or R6 messages (for example, Data Path messages).
in seconds for the R4 or R6 messages (for example, Data Path messages).
Product
ASN GW
Privilege
Administrator
Syntax
Sets the total timeout duration to 15 seconds to actively relayed R4 or R6 messages.
Default: 15
Specifies the maximum allowable timeout duration for the ASN GW service to actively relay the R4 or R6
messages.
Specifies the maximum allowable timeout duration for the ASN GW service to actively relay the R4 or R6
messages.
is measured in seconds. Configure as an integer from 5 through 65535.
Usage
Use this command to enable the active relay of R4 and R6 messages and also to configure the maximum
timeout duration for the actively relayed R4 or R6 messages by ASN GW.
By default, the system is pre-configured for passive relay functionality for R4 and R6 messages.
timeout duration for the actively relayed R4 or R6 messages by ASN GW.
By default, the system is pre-configured for passive relay functionality for R4 and R6 messages.
Example
The following command configures the timeout duration of
The following command configures the timeout duration of
seconds for actively relayed R4 or R6 messages: