Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Gateway Service Configuration Mode Commands
▀ idle-mode
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
idle-mode
Use this command to configure the time in seconds that an ASN GW service waits to place a session in idle mode or
reactivates an idle session after the specified time for exit timeout. This occurs if there is no activity for the amount of
time you specified.
reactivates an idle session after the specified time for exit timeout. This occurs if there is no activity for the amount of
time you specified.
Product
ASN GW
Privilege
Administrator
Syntax
Resets the idle mode durations to their respective default values.
Disables/removes the configured idle mode entry and/or exit timeout duration for a session.
Default: 60
Specifies the maximum duration in seconds allowed for idle mode entry for a session.
Specifies the maximum duration in seconds allowed for idle mode entry for a session.
is measured in seconds. Configure as an integer from 1 through 100000.
Default: 60
Specifies the maximum duration in seconds allowed for session to reenter active mode after idle mode exit.
Specifies the maximum duration in seconds allowed for session to reenter active mode after idle mode exit.
is measured in seconds. Configure as an integer from 1 through 100000.
Default: 4069
Specifies the maximum time (in seconds) allowed for a session to remain in idle mode.
Specifies the maximum time (in seconds) allowed for a session to remain in idle mode.
is an
integer from 128 to 65535.
Usage
Use this command to configure the ASN GW service to send a session for idle mode or active mode after
specified duration of time.
specified duration of time.
Example
The following command configures the idle mode entry timeout value to
The following command configures the idle mode entry timeout value to
seconds: