Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Gateway Service Configuration Mode Commands
▀ retransmission-timeout
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
retransmission-timeout
Use this command to configure the non-response time before the system re-attempts to send R6 control packets to the
BS.
BS.
Product
ASN GW
Privilege
Administrator
Syntax
Sets the timeout duration to 3 seconds before R6 control packets are retransmitted.
Disables or removes the configured timeout duration for the retransmission of R6 control packets.
Default: 3
Specifies the the number of seconds for the ASN GW service to wait for a response from the BS before it (a)
attempts to communicate with the BS again (if the system is configured to retry the BS), or (b) marks the BS
as unreachable.
Specifies the the number of seconds for the ASN GW service to wait for a response from the BS before it (a)
attempts to communicate with the BS again (if the system is configured to retry the BS), or (b) marks the BS
as unreachable.
is measured in seconds and can be configured to any integer value between 1 and 1,000.
Usage
Use this command in conjunction with the
command to configure the ASN GW
services behavior when it does not receive a response from a particular BS.
Use the
Use the
command to delete a previously configured timeout value. If
after deleting the lifetime setting you desire to return the lifetime parameter to its default setting, use the
command.
The chassis is shipped with the retransmission timeout set to 3 seconds.
Example
The following example configures a retransmission timeout value of 5 seconds:
The following example configures a retransmission timeout value of 5 seconds:
The following command deletes a previously configured retransmission-timeout setting: