Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ASN Paging Controller Configuration Mode Commands
▀ retransmission-timeout
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
retransmission-timeout
Use this command to configure the amount of time that must pass before the system re-attempts to send R6 control
packets to the BS.
packets to the BS.
Product
ASN PC-LR
Privilege
Administrator
Syntax
Sets the timeout duration to 3 seconds for retransmission of R6 control packets.
Disables or removes the configured timeout duration for retransmission of R6 control packets.
Default: 3
Specifies the maximum time for the ASN paging controller service to wait for a response from the BS before
it a) attempts to communicate with the BS again (if the system is configured to retry the BS), or b) marks the
BS as unreachable.
Enter an integer between 1 and 1000 as the
Specifies the maximum time for the ASN paging controller service to wait for a response from the BS before
it a) attempts to communicate with the BS again (if the system is configured to retry the BS), or b) marks the
BS as unreachable.
Enter an integer between 1 and 1000 as the
in seconds.
Usage
Use this command in conjunction with the
command to configure the ASN paging
controller services behavior when it does not receive a response from a particular BS.
Use the
Use the
command to delete a previously configured timeout value. If,
after deleting the lifetime setting you desire to return the lifetime parameter to its default setting, use the
command.
The chassis is shipped from the factory with the retransmission timeout set to 3 seconds.
Example
The following command configures a retransmission timeout value of 5 seconds:
The following command configures a retransmission timeout value of 5 seconds:
The following command deletes a previously configured retransmission-timeout setting: