Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Bulk Statistics Configuration Mode Commands
receiver ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
receiver
Configures host system to receive bulkstats information through TFTP transfer.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Removes the receiver specified from the list of receivers where data files are sent.
Determines how bulkstats are delivered to the primary and secondary receivers.
Default:
Default:
: Files are transferred to both the primary and secondary receivers. If either transfer isn't
possible, the file is transferred when possible. The system continues to hold in memory as much data as
possible until the data has been successfully transferred to both receivers. Data is only discarded if the in-
memory data reaches the configured limit. Refer to the
possible until the data has been successfully transferred to both receivers. Data is only discarded if the in-
memory data reaches the configured limit. Refer to the
command.
: Files are transferred to the secondary receiver if the primary receiver fails. In-
memory data is erased once the data is transferred to either the primary or secondary receiver. This is the
default behavior.
default behavior.
Specifies the IP address of the receiver of interest.
must be specified using the standard IPv4
dotted decimal notation.
Primary and secondary are used to indicate the order in which receivers are connected. The secondary is used
when the primary is unreachable.
when the primary is unreachable.
: indicates the receiver is the primary receiver of data.
: indicates the receiver is the secondary receiver of data.
Specifies the method by which data is transferred to the receiver.
[
]
: the FTP protocol shall be used for data file
transfer.
specifies the user to provide for remote system secure logins and must be an alpha
and/or numeric string of 1 through 31 characters in length. The password to use for remote system