Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Card Configuration Mode Commands
link-aggregation ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
link-aggregation
Configures the link-aggregation system-priority for a Quad Gig-E line card (QGLC). This parameter is usually changed
to match the feature requirements of the remote switch.
to match the feature requirements of the remote switch.
Product
WiMAX, PDSN, HA, FA, GGSN, SGSN
Privilege
Security Administrator, Administrator
Syntax
Resets the configuration to the default.
This command sets the system priority used by LACP to form the system ID.
priority is a hex value in the range of 0x0000 to 0xFFFF.
Default system priority value is 0x8000 (32768).
priority is a hex value in the range of 0x0000 to 0xFFFF.
Default system priority value is 0x8000 (32768).
When enabled, port line down and port link up events are generated.
Default is disabled.
Default is disabled.
Instructs the system to execute the command without additional prompting for command confirmation.
Usage
This value is combined with the Master port‘s MAC address to form the system ID. A system is a packet
processing card and its associated QGLC(s) The highest system ID priority (the lowest number) handles
dynamic changes.
For additional usage and configuration information for the link aggregation feature, go to Configuring Link
Aggregation in the Cisco ASR 5000 Series System Administration Guide.
processing card and its associated QGLC(s) The highest system ID priority (the lowest number) handles
dynamic changes.
For additional usage and configuration information for the link aggregation feature, go to Configuring Link
Aggregation in the Cisco ASR 5000 Series System Administration Guide.
Important:
Not supported on all platforms
Example
The following command configures the link aggregation system-priority to 10640:
The following command configures the link aggregation system-priority to 10640: