Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Context Configuration Mode Commands
▀ ipv6 route
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
ipv6 route
Configures a static IPv6 route to the next-hop router.
Product
All
Privilege
Administrator
Syntax
Removes the specified static route.
Specifies a destination IPv6 address or group of addresses that will use this route.
must be specified in IPv6 colon separated notation.
Specifies the name of the interface on this system associated with the specified route or next-hop address.
must be an existing interface name on the system and be from 1 to 79 alpha and/or numeric characters.
The IPv6 address of the directly connected next hop device.
must be specified in IPv6
colon separated notation.
Default: 0
Defines the number of hops to the next gateway.
Defines the number of hops to the next gateway.
must be an integer value from 0 to 255.
Default: 1
Indicates the administrative preference of the route. A low precedence specifies that this route takes
preference over the route with a higher precedence.
Indicates the administrative preference of the route. A low precedence specifies that this route takes
preference over the route with a higher precedence.
must be an integer value from 1 to 254.
Usage
Use this command to create a static route and send data traffic to a next-hop device.
Example
Use the following example to configure a static route with ipv6 prefix/length
Use the following example to configure a static route with ipv6 prefix/length
to the next hop interface
: