Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Crypto Transform Set Configuration Mode Commands
▀ mode
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
mode
Configures the IPSec encapsulation mode.
Product
PDSN, HA, GGSN, PDIF, SCM
Privilege
Security Administrator, Administrator
Syntax
Default: Disabled
Specifies that the transform set only protects the upper layer protocol data portions of an IP datagram, leaving
the IP header information unprotected.
Specifies that the transform set only protects the upper layer protocol data portions of an IP datagram, leaving
the IP header information unprotected.
Important:
This mode should only be used if the communications end-point is also the cryptographic end-point.
Default: Enabled
Specifies that the transform set protects the entire IP datagram as displayed in the following figure.
This mode should be used if the communications end-point is different from the cryptographic end-point as in
a VPN.
Specifies that the transform set protects the entire IP datagram as displayed in the following figure.
This mode should be used if the communications end-point is different from the cryptographic end-point as in
a VPN.
Usage
This command specifies the encapsulation mode for the transform set.
Example
The following command configures the transforms set‘s encapsulation mode to transport:
The following command configures the transforms set‘s encapsulation mode to transport: