Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Exec Modes Commands (D-S)
▀ sgsn op
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
sgsn op
These commands instruct the SGSN to begin specific operations or functions.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
This command accesses a built-in conversion tool to convert SS7 point codes, according to identified
variants, from dotted-decimal format to decimal format and visa versa .
variants, from dotted-decimal format to decimal format and visa versa .
Enter an SS7 point code in either dotted-decimal format or decimal format.
Identify the appropriate variant for the point code:
The
command enables the operator to perform a range of live control functions (e.g, reset, block,
unblock) for various types of virtual connections based on the signalling type of the NSE:
Identifies a Frame Relay NSE.
Identifies an IP NSE.
Identifies an IP NSE.
Identifies the operation to be performed for the NSE connection (if available for the selected
signalling type) :
- Blocks signal flow through all network service virtual connections
(NSVC) for the specified NSE:
Enter an integer from 0 to 65535.
- SGSN initiates flow
control at the defined percentage rate to limit the flow through the BSSGP virtual connection (BVC)
for the specified NSE and optionally for a specified BVC.
for the specified NSE and optionally for a specified BVC.
Enter an integer from 0 to 100.
Enter an integer from 0 to 65000.
Enter an integer from 0 to 65535.
- SGSN initiates a BVC-Reset on the
specified BVC and NSE:
Enter an integer from 0 to 65000.
Enter an integer from 0 to 65535.
- SGSN initiates
NS-Block or NS-Unblock for the specified NSVC of the specified NSE: