Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Exec Modes Commands (D-S)
▀ srp initiate-switchover
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
srp initiate-switchover
This command changes the device status on the primary and backup HA or GGSN systems configured for Interchassis
Session Recovery support.
Session Recovery support.
Product
HA, GGSN PDIF
Privilege
Security Administrator, Administrator, Operator, Inspector
Syntax
Specifies the timeout value in seconds to initiate the post-switchover process. The value must be an integer
from 0 through 3600.
from 0 through 3600.
During a switchover, reset the route-modifier to the initial value.
Default: 300
Specifies the number of seconds before a forced switchover occurs. seconds must be a value in the range
from 0 through 65535.
Specifies the number of seconds before a forced switchover occurs. seconds must be a value in the range
from 0 through 65535.
Indicates that the command is to execute without any additional prompt and confirmation from the user.
Usage
This command executes a forced switchover from active to inactive. The command must be executed on the
active system and switches the active system to the inactive state and the inactive system to an active state.
active system and switches the active system to the inactive state and the inactive system to an active state.
Example
The following initiates a switchover in
The following initiates a switchover in
seconds.