Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Exec Mode Show Commands (M-P)
show multicast-sessions ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
If no keywords are specified before
, information for all multicast sessions is displayed. If keywords are
specified before
, all information is displayed with no further options being allowed.
Displays multicast session information for the call specified by
The call must be specified as an 8-byte
hexadecimal number.
The slot number of the processing card by which the subscriber session is processed.
is a slot
number from 1 through 7 or 10 through 16.
Shows information for subscriber sessions that are dormant (not transmitting or receiving data).
Displays information for a specific BCMCS flow, defined by
The flow ID must be a hexadecimal
number.
Displays information for multicast sessions according to the type of flow.
Shows all multicast sessions for the flow ID type ―flow‖.
Shows all multicast sessions for the flow ID type ―program‖.
Show multicast sessions for a specific multicast address. Must be followed by the IP address of an interface,
using dotted decimal notation.
using dotted decimal notation.
Displays information for multicast sessions connected via the packet control function, defined by
. The address must be specified using the standard IPv4 dotted decimal notation.
Displays information for multicast session connected to the packet data service
The packet data
service must have been previously configured.
Indicates the output of the command is to be piped (sent) to the command specified. A command to send
output to must be specified.
Please refer to the Regulating a Command‘s Output of Command Line Interface Reference for details on the
usage of
output to must be specified.
Please refer to the Regulating a Command‘s Output of Command Line Interface Reference for details on the
usage of
and
.
Usage
Use this command to view information about multicast sessions.