Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold aaa-retry-rate ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold aaa-retry-rate
Configures AAA retry rate thresholds for the system.
Product
PDSN, GGSN, HA, ASN GW
Privilege
Security Administrator, Administrator
Syntax
Default: 5
The high threshold percent of AAA request message retries that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh can be configured to any integer value between 0 and 100.
The high threshold percent of AAA request message retries that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh can be configured to any integer value between 0 and 100.
Default: 5
The low threshold percent of AAA request message retries that maintains a previously generated alarm
condition. If the percentage of retries falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
low_thresh can be configured to any integer value between 0 and 100.
The low threshold percent of AAA request message retries that maintains a previously generated alarm
condition. If the percentage of retries falls beneath the low threshold within the polling interval, a clear alarm
will be generated.
low_thresh can be configured to any integer value between 0 and 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
AAA request message retry rate thresholds generate alerts or alarms based on the percentage of request
messages (both authentication and accounting) that were retried during the specified polling interval. The
percentage is based on a message count taken for all AAA authentication and accounting servers that the
system is configured to communicate with.
Alerts or alarms are triggered for request message retries based on the following rules:
messages (both authentication and accounting) that were retried during the specified polling interval. The
percentage is based on a message count taken for all AAA authentication and accounting servers that the
system is configured to communicate with.
Alerts or alarms are triggered for request message retries based on the following rules:
Enter condition: Actual retry percentage ³ High Threshold
Clear condition: Actual retry percentage < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example
The following command configures a AAA message retry rate high threshold percentage of 25 and a low threshold
percentage of 10 for an system using the Alarm thresholding model:
The following command configures a AAA message retry rate high threshold percentage of 25 and a low threshold
percentage of 10 for an system using the Alarm thresholding model: