Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold fw-deny-rule ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold fw-deny-rule
This command configures thresholds for Stateful Firewall Deny Rule.
Product
FW
Privilege
Security Administrator, Administrator
Syntax
Disables the threshold and sets
and
to the default values.
Specifies the Stateful Firewall Deny-Rule threshold value, which if met or exceeded generates an alert or
alarm.
alarm.
must be an integer from 0 through 1000000.
Default: 0
Specifies the Stateful Firewall Deny-Rule alarm clear threshold value. If, in the same polling interval, the
threshold falls below
threshold falls below
a clear alarm is generated.
must be an integer from 0 through 1000000.
Default: 0
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the low threshold.
Usage
When the number of Deny-Rule exceeds a given value, a threshold is raised and it is cleared when the
number of Deny-Rule fall below a value within the polling interval.
Refer to the
number of Deny-Rule fall below a value within the polling interval.
Refer to the
command to configure the polling interval, and the
command to enable thresholding for this value.
Example
The following command configures a Stateful Firewall Deny Rule high threshold of
The following command configures a Stateful Firewall Deny Rule high threshold of
and a low threshold of
for a system using the Alarm Thresholding model: