Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold mgmt-cpu-utilization ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold mgmt-cpu-utilization
Configures the thresholds for CPU utilization.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold CPU utilization percentage that must be met or exceeded within the polling interval to
generate an alert or alarm.
high_thresh can be configured to any integer value between 0 and 100.
The high threshold CPU utilization percentage that must be met or exceeded within the polling interval to
generate an alert or alarm.
high_thresh can be configured to any integer value between 0 and 100.
The low threshold CPU utilization percentage that maintains a previously generated alarm condition. If the
utilization percentage falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh can be configured to any integer value between 0 and 100.
utilization percentage falls beneath the low threshold within the polling interval, a clear alarm will be
generated.
low_thresh can be configured to any integer value between 0 and 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
CPU utilization thresholds generate alerts or alarms based on the utilization percentage of each SPC/SMC
CPU during the specified polling interval. Although, a single threshold is configured for both SPC/SMC
CPUs, separate alerts or alarms can be generated for each CPU.
Alerts or alarms are triggered for SPC/SMC CPU utilization based on the following rules:
CPU during the specified polling interval. Although, a single threshold is configured for both SPC/SMC
CPUs, separate alerts or alarms can be generated for each CPU.
Alerts or alarms are triggered for SPC/SMC CPU utilization based on the following rules:
Enter condition: Average measured CPU utilization for last 5 minutes ³ High Threshold
Clear condition: Average measured CPU utilization for last 5 minutes < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Important:
This command is not supported on all platforms.
Example