Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold per-service-lns-sessions ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold per-service-lns-sessions
Configures thresholds for the number of LNS sessions per LNS service in the system.
Product
PDSN, GGSN, HA, ASN GW
Privilege
Security Administrator, Administrator
Syntax
Default: 0
The high threshold number of LNS sessions for any one LNS service that must be met or exceeded within the
polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 500000. A value of 0 disables the
threshold.
The high threshold number of LNS sessions for any one LNS service that must be met or exceeded within the
polling interval to generate an alert or alarm.
The number can be configured to any integer value from 0 through 500000. A value of 0 disables the
threshold.
Default: 0
The low threshold number of LNS sessions for any one LNS service that maintains a previously generated
alarm condition. If the number of LNS sessions falls beneath the low threshold within the polling interval, a
clear alarm will be generated.
The number can be configured to any integer value between 0 and 500000. A value of 0 disables the
threshold.
The low threshold number of LNS sessions for any one LNS service that maintains a previously generated
alarm condition. If the number of LNS sessions falls beneath the low threshold within the polling interval, a
clear alarm will be generated.
The number can be configured to any integer value between 0 and 500000. A value of 0 disables the
threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of LNS sessions for any LNS service in the system is equal
to or greater than the set limit.
Alerts or alarms are triggered for LNS sessions based on the following rules:
to or greater than the set limit.
Alerts or alarms are triggered for LNS sessions based on the following rules:
Enter condition: Actual number of LNS sessions for any LNS service ³ High Threshold
Clear condition: Actual number of LNS sessions < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command to configure the polling interval and the
command to enable thresholding for this value.
Example
The following command configures a LNS session per service high threshold count of
The following command configures a LNS session per service high threshold count of
for an system using the
Alert thresholding model: