Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Global Configuration Mode Commands
threshold poll port-rx-utilization ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
threshold poll port-rx-utilization
Enables the generation of alerts or alarms based on the port utilization percentage for data received during the polling
interval.
interval.
Product
All
Privilege
Administrator Security Administrator
Syntax
Configures the threshold polling interval in multiples of 30 seconds from 30 to 60000
Usage
Receive port utilization thresholds generate alerts or alarms based on the utilization percentage of each
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis configured using the port
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis configured using the port
command syntax.
Important:
This command is not available on all platforms
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
(The transmitted and received percentages are combined.) Therefore, to avoid redundant alarms, it is recommended that
only the receive or transmit utilization threshold be configured.
only the receive or transmit utilization threshold be configured.
Example
Use the following example to configure a threshold poll interval of
Use the following example to configure a threshold poll interval of
seconds (5 minutes)