Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
IuPS Service Configuration Mode Commands
blacklist-timeout-gtpu-bind-addresses ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
blacklist-timeout-gtpu-bind-addresses
This command specifies the time period that a GTP-U bind address (loopback address) will not be used (is blacklisted)
in RAB-Assignment requests after a RAB assignment request, with that GTP-U bind address, has been rejected by an
RNC with the cause - Unspecified Error. This is a failure at the RNC‘s GTP-U IP interface.
in RAB-Assignment requests after a RAB assignment request, with that GTP-U bind address, has been rejected by an
RNC with the cause - Unspecified Error. This is a failure at the RNC‘s GTP-U IP interface.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Resets the blacklist time to 60 seconds.
Number of seconds that the GTP-U bind (loopback) address will not be used in a RAB-Assignment request.
: Must be an integer from 1 to 1800.
Usage
Use this command to configure the blacklist period.
Example
The following command specifies a 15 minutes blacklist period.
The following command specifies a 15 minutes blacklist period.