Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
ACS Packet Filter Configuration Mode Commands
priority ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
priority
This command configures the packet filter‘s priority.
Important:
This command is deprecated in certain 9.0 release and in 10.0 and later releases. The precedence
values of packet filters (those from Dynamic Rules, and those from Predefined Rules) are assigned by the PCEF based
on an internal process.
on an internal process.
Product
ACS
Privilege
Security Administrator, Administrator
Syntax
Removes the priority configuration, if previously configured.
Specifies this packet filter‘s priority, and must be an integer from 0 through 255.
Usage
Use this command to configure the packet filter‘s priority. The priority must be configured for the packet
filter to be used in a TFT. Packets are compared against packet filters in a prioritized fashion, with 0 being the
highest priority. Without this setting, this filter will not be used.
filter to be used in a TFT. Packets are compared against packet filters in a prioritized fashion, with 0 being the
highest priority. Without this setting, this filter will not be used.
Example
The following command configures the packet filter‘s priority as :
The following command configures the packet filter‘s priority as :