Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Subscriber Configuration Mode Commands
radius accounting ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
radius accounting
Sets the RADIUS accounting parameters for the subscriber or domain. This command takes precedence over the similar
context configuration command. This command is disabled by default.
context configuration command. This command is disabled by default.
Product
All
Privilege
Administrator
Syntax
: Indicates the time (in seconds) between updates to session counters (log
file on RADIUS or AAA event log) during the session.
must be an integer from 50 to 40000000.
Caution:
Interim interval settings received from the RADIUS server take precedence over this setting on the
system. While the low limit of this setting on the system is a minimum of 50 seconds, the low limit setting on the
RADIUS server can be as little as 1 second. To avoid increasing network traffic unnecessarily and potentially reducing
network and system performance, do not set this parameter to a value less than 50 on the RADIUS server.
RADIUS server can be as little as 1 second. To avoid increasing network traffic unnecessarily and potentially reducing
network and system performance, do not set this parameter to a value less than 50 on the RADIUS server.
: If RADIUS accounting is enabled, send this Acct-Status-Type message when required by normal
operation
: If RADIUS accounting is enabled, suppress the sending of this Acct-Status-Type message.
Specifies the identification number of the IP address list to use for the subscriber for remote address-based
accounting.
accounting.
: Specifies the RADIUS accounting remote IP address list identifier for remote-address accounting
for the subscriber.
must be an integer from 1 through 65535.
This command is used as part of the Remote Address-based accounting feature and associates the subscriber
with a list of remote addresses. Remote address accounting data is collected each time the subscriber
communicates with any of the addresses specified in the list.
Remote address lists are configured using the
with a list of remote addresses. Remote address accounting data is collected each time the subscriber
communicates with any of the addresses specified in the list.
Remote address lists are configured using the
keyword in the
command in the Context Configuration mode.
Default:
Specifies if the radius accounting mode is either session-based or access-flow-based.