Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Service Configuration Procedures
Creating and Configuring Ethernet Interfaces and Ports ▀
Cisco ASR 5000 Series Access Service Network Gateway Administration Guide ▄
OL-22953-01
Creating and Configuring Ethernet Interfaces and Ports
To create and configure a Simple and/or Mobile IP data application interface (R4, R6, DHCP, R3, or CSN), you need to
do the following:
do the following:
Name the interface
Assign an IP address and subnet mask to the interface
Assign a physical port for use by the interface
Bind the port to the interface
Optionally configure port switchover on L3 connectivity failure
This section provides the minimum instruction set for configuring interfaces and ports to allow the system to
communicate on the network. Commands that configure additional interface or port properties are provided in the
Ethernet Port Configuration mode and Ethernet Interface Configuration mode chapters of the Command Line Interface
Reference.
communicate on the network. Commands that configure additional interface or port properties are provided in the
Ethernet Port Configuration mode and Ethernet Interface Configuration mode chapters of the Command Line Interface
Reference.
Caution:
To ensure that system line card and port-level redundancy mechanisms function properly, disable the
Spanning Tree protocol on devices connected directly to any system port. Failure to turn off the Spanning Tree protocol
may result in failures in the redundancy mechanisms or service outage.
may result in failures in the redundancy mechanisms or service outage.
This section provides instructions for creating and configuring Ethernet interfaces and ports. These instructions assume
that you are at the root prompt for the Exec mode:
that you are at the root prompt for the Exec mode:
Step 1
Enter the configuration mode by typing:
The following prompt appears:
Step 2
Enter context configuration mode typing:
context_name is the name of the context in which to create and configure the interface. The name must be from 1 to 79
alpha and/or numeric characters and is case sensitive.
alpha and/or numeric characters and is case sensitive.
The following prompt appears: