Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Service Configuration Procedures
Creating and Configuring Ethernet Interfaces and Ports ▀
Cisco ASR 5000 Series Access Service Network Gateway Administration Guide ▄
OL-22953-01
Step 12 Enable the port by entering the following command:
Step 13 Bind the port to the interface. Binding associates the port and all of its settings to the interface. Enter the following
command to bind the port to the interface:
Keyword/Variable
Description
The name of the interface that was configured in step 3 of this section.
The name of the context in which the interface was selected.
Step 14 Enter the following command to exit the Ethernet Port Configuration mode:
The following prompt appears:
Step 15 Configure a static route for the interface, if needed, by following these instructions:
Step a
Enter the context configuration mode by typing the following command:
context_name is the name of the context in which the interface was configured.
The following prompt appears:
Step b
Enter the following command to configure the static route(s):
Keyword/Variable
Description
The IP address of the target network or subnet.