Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Service Configuration Procedures
▀ Creating and Configuring FA Services
▄ Cisco ASR 5000 Series Access Service Network Gateway Administration Guide
OL-22953-01
Creating and Configuring FA Services
FA services are configured within contexts and allow the system to function as an FA in the 3G wireless data network.
Important:
This section provides the minimum instruction set for configuring an FA service so the system can
process data sessions. Commands for configuring additional FA service properties are provided in the Command Line
Interface Reference. Additionally, when you configure mobile IP, take into account the MIP timing considerations
discussed in Appendix 1‚ R_MIP Timer Considerations.
Interface Reference. Additionally, when you configure mobile IP, take into account the MIP timing considerations
discussed in Appendix 1‚ R_MIP Timer Considerations.
This section provides instructions for configuring FA services. These instructions assume that you are at the root prompt
for the Exec mode:
for the Exec mode:
Step 1
Enter the configuration mode by typing:
The following prompt appears:
Step 2
Enter the context configuration mode by typing the following command:
context_name is the name of the system context designated for FA service configuration. The name must from 1 to 79
alpha and/or numeric characters and is case sensitive.
alpha and/or numeric characters and is case sensitive.
The following prompt appears:
Step 3
Enter the following command to create the FA service:
fa_service_name is the name designated for the FA service. The name must be from 1 to 63 alpha and/or numeric
characters and is case sensitive.
characters and is case sensitive.
The following prompt appears: