Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Subscriber Overcharging Protection
▀ Verifying Your Configuration
▄ Cisco ASR 5000 Series Enhanced Feature Configuration Guide
OL-22982-01
Verifying Your Configuration
This section explains how to display and review the configurations after saving them in a .cfg file as described in
Verifying and Saving Your Configuration chapter of this guide and also to retrieve errors and warnings within an active
configuration for a service.
Verifying and Saving Your Configuration chapter of this guide and also to retrieve errors and warnings within an active
configuration for a service.
Important:
All commands listed here are under Exec mode. Not all commands are available on all platforms.
These instructions are used to verify the overcharging protection support configuration.
Step 1
Verify that your overcharging support is configured properly by entering the following command in Exec Mode:
The output of this command displays the configuration for overcharging protection configured in the GGSN service
.
Step 2
Verify that GTP-C private extension is configured properly for GGSN subscribers by entering the following command
in Exec Mode:
in Exec Mode:
The output of this command displays the LORC state information and number of out packets dropped due to LORC.