Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung

Seite von 580
IP Header Compression   
▀  Overview 
 
▄  Cisco ASR 5000 Series Enhanced Feature Configuration Guide 
OL-22983-01   
Overview 
The system supports IP header compression on the PPP tunnels established over the EVDO-RevA A10 links and also 
over the GRE tunnel that is connected to the PCF to support EVDO-RevA Service Option 67 (SO67). 
By default IP header compression using the VJ algorithm is enabled for subscribers using PPP. 
Note that you can use the default VJ header compression algorithm alone, configure the use of RoHC header 
compression only, or use both VJ and RoHC IP header compression. 
 
Van Jacobsen (VJ) - The RFC 1144 (CTCP) header compression standard was developed by V. Jacobson in 
1990. It is commonly known as VJ compression. It describes a basic method for compressing the headers of 
IPv4/TCP packets to improve performance over low speed serial links. 
 
RObust Header Compression (RoHC) - The RFC 3095 (RoHC) standard was developed in 2001. This 
standard can compress IP/UDP/RTP headers to just over one byte, even in the presence of severe channel 
impairments. This compression scheme can also compress IP/UDP and IP/ESP packet flows. RoHC is intended 
for use in wireless radio network equipment and mobile terminals to decrease header overhead, reduce packet 
loss, improve interactive response, and increase security over low-speed, noisy wireless links. 
Important:
  Use of RoHC requires that a valid RoHC license key be installed. Contact your local Sales or Support 
representative for information on how to obtain a license. 
In addition, you can configure RoHC profiles that define RoHC Compressor and Decompressor parameters. These 
RoHC profiles can be applied to subscribers. 
You can also turn off all IP header compression for a subscriber. 
The procedures in this chapter describe how to configure the IP header compression methods used, but for RoHC over 
PPP the Internet Protocol Control Protocol (IPCP) negotiations determine when they are used. 
Implementing IP header compression provides the following benefits: 
 
 
Improves interactive response time 
 
Allows the use of small packets for bulk data with good line efficiency 
 
Allows the use of small packets for delay sensitive low data-rate traffic 
 
Decreases header overhead. 
 
Reduces packet loss rate over lossy links.