Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Proxy-Mobile IP
▀ Configuring Proxy Mobile-IP Support
▄ Cisco ASR 5000 Series Enhanced Feature Configuration Guide
OL-22983-01
Attribute
Description
Values
SN-Simultaneous-
SIP-MIP
OR
SN1-
Simultaneous-
SIP-MIP
SIP-MIP
OR
SN1-
Simultaneous-
SIP-MIP
Indicates whether or not a subscriber can simultaneously access both Simple
IP and Mobile IP services.
IP and Mobile IP services.
Important:
Regardless of the configuration of this attribute,
the FA facilitating the Proxy Mobile IP session will not allow
simultaneous Simple IP and Mobile IP sessions for the MN.
simultaneous Simple IP and Mobile IP sessions for the MN.
Disabled (0)
Enabled (1)
SN-PDSN-
Handoff- Req-IP-
Addr
OR
SN1-PDSN-
Handoff- Req-IP-
Addr
Handoff- Req-IP-
Addr
OR
SN1-PDSN-
Handoff- Req-IP-
Addr
Specifies whether or not the system should reject and terminate the
subscriber session when the proposed address in IPCP by the mobile does not
match the existing address that was granted by the chassis during an Inter-
chassis handoff.
This can be used to disable the acceptance of 0.0.0.0 as the IP address
proposed by the MN during the IPCP negotiation that occurs during an Inter-
chassis handoff.
This attribute is disabled (do not reject) by default.
subscriber session when the proposed address in IPCP by the mobile does not
match the existing address that was granted by the chassis during an Inter-
chassis handoff.
This can be used to disable the acceptance of 0.0.0.0 as the IP address
proposed by the MN during the IPCP negotiation that occurs during an Inter-
chassis handoff.
This attribute is disabled (do not reject) by default.
Disabled - do not
reject (0)
reject (0)
Enabled - reject (1)
3GPP2-MIP-HA-
Address
Address
This attribute sent in an Access-Accept message specifies the IP Address of
the HA.
Multiple attributes can be sent in Access Accept. However, only the first two
are considered for processing. The first one is the primary HA and the second
one is the secondary (alternate) HA used for HA Failover.
the HA.
Multiple attributes can be sent in Access Accept. However, only the first two
are considered for processing. The first one is the primary HA and the second
one is the secondary (alternate) HA used for HA Failover.
IPv4 Address
Configuring Local Subscriber Profiles for Proxy-MIP on a PDSN
This section provides information and instructions for configuring local subscriber profiles on the system to support
Proxy Mobile IP on a PDSN.
Proxy Mobile IP on a PDSN.
Verify that your settings for the subscriber(s) just configured are correct.