Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Routing
OSPF Routing ▀
Cisco ASR 5000 Series Enhanced Feature Configuration Guide ▄
OL-22983-01
Enabling OSPF Over a Specific Interface
After you enable OSPF, specify the networks on which it will run. Use the following command to enable OSPF:
Important:
The default cost for OSPF on the system is 10. To change the cost, refer to the ip ospf cost command
in the Ethernet Interface Configuration mode. For detailed information on this command refer to the Cisco ASR 5000
Series Command Line Interface Reference.
Series Command Line Interface Reference.
Notes:
Save your configuration as described in Verifying and Saving Your Configuration.
Redistributing Routes Into OSPF (Optional)
Redistributing routes into OSPF means any routes from another protocol that meet specified a specified criterion, such
as route type, metric, or rule within a route-map, are redistributed using the OSPFv2 protocol to all OSPF areas. This is
an optional configuration.
as route type, metric, or rule within a route-map, are redistributed using the OSPFv2 protocol to all OSPF areas. This is
an optional configuration.
Notes:
Save your configuration as described in Verifying and Saving Your Configuration.
Confirming OSPF Configuration Parameters
To confirm the OSPF router configuration, use the following command and look for the section labeled router ospf in
the screen output:
the screen output: