Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
MME Service Configuration Procedures
MME Service Configuration ▀
Cisco ASR 5000 Series Mobility Management Entity Administration Guide ▄
OL-22987-01
65
ip address <
ip_address
>
end
Notes:
<vpn_ctxt_name> is name of the source context in which MME service is to configure.
<intf_name> is name of the interface which is to be used for S1-MME reference between MME and eNodeB.
Creating and Binding MME Service
Use the following example to create the MME service and bind it to a local IP address. This example also configures the
SCTP port for communication with eNodeB and specifies an identifier for MME service in LTE network:
SCTP port for communication with eNodeB and specifies an identifier for MME service in LTE network:
configure
context <
vpn_ctxt_name
>
mme-service <
mme_svc_name
>
bind s1-mme address <
ip_address
>
s1-mme sctp port <
port_num
>
mme-id group-id <
grp_id
> mme-code <
mme_code
>
end
Notes:
A maximum of 256 services (regardless of type) can be configured per system.
<ip_address> is the local IP address of this MME service and should not conflict with any other service.
<port_num> is the SCTP port on which MME service will listen from eNodeB.
Configuring Network Id Parameters
Use the following example to configure the network parameters.
configure
context <
vpn_ctxt_name
>
mme-service <
mme_svc_name
>
dest-sctp address <
ip_address
>
dest-sctp port <
port_num
>
plmn-id mcc <
mcc_value
> mnc <
mnc_value
>