Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung

Seite von 113
Troubleshooting   
▀  Troubleshooting the PDIF 
 
▄  Cisco ASR 5000 Series Packet Data Interworking Function Administration Guide 
OL-22963-01   
HA Failure 
 
If the HA fails, there is a health monitoring mechanism in the PDIF to generate an SNMP notification. At this time, all 
traffic to and from the MS is black-holed. DPD/liveness checks from the MS are still in order, so the connection remains 
in a hung state until the Proxy-MIP lifetime timer expires. When the PDIF attempts to re-register with the HA, the re-
registration attempt fails, and the PDIF tears down the IPSec session. In this case, the MS attempts to establish a new 
IPSec session with the PDIF. If the HA has recovered, the IPSec session and Proxy-MIP session are re-established. 
 
General Error Cases for Mobile-IP Networks 
The following are possible scenarios for mobile IP installations. 
Table 8.  Mobile IP Error Scenarios 
 
Error Description
 
Comments
 
1
 
For Mobile-IP session, 
CREATE_CHILD_SA should not include 
CP payload for 
INTERNAL_IP4_ADDRESS
 
If it is included, the session attempts are rejected and the complete IKEv2 
session is disconnected.
 
2
 
For mobile IP session, 
CREATE_CHILD_SA request should have 
Tsi = HoA
 
If Tsi is not the same as HoA, PDIF falls back to simple IP when session setup 
timer expires (if this is allowed by configuration).
 
3
 
Diameter Error codes received from HSS
 
PDIF allows configurable for each error code whether to continue with the 
session setup or disconnect the session. Error logs are created.
 
4
 
MS does not initiate CREATE_CHILD_SA 
after PDIF/FA sends successful RRP
 
The session setup timer in PDIF/FA expires and session falls back to simple IP 
(if this is allowed by configuration).
 
5
 
If MS does not send RRQ when 
first/implicit TIA based SA created.
 
The session setup timer expires and session is disconnected clearing both 
IKEv2 SA and implicit TIA-based IPSec SA.
 
6
 
CREATE_CHILD_SA request fails after 
successful MIP registration.
 
Session falls back to simple IP when session setup timer expires (if this is 
allowed by configuration).
 
7
 
TIA pool is full and hence no address to 
assign during the initial IKEv2 negotiations
 
PDIF tears down the whole session attempt.
 
8
 
MS does not specify 
INTERNAL_IP4_ADDR attribute during 
IKEv2 negotiations.
 
PDIF tears down the whole session attempt since there is no way of assigning 
IP address to mobile
 
9
 
MS does specify a valid IP address 
INTERNAL_IP4_ADDR attribute during 
IKEv2 negotiations.
 
If MS gives an IP address, and if it is available in the static pool configured in 
the PDIF, then PDIF allows session to be established using the specified IP 
address.If MS gives the IP address of 0.0.0.0 then PDIF assigns an IP address 
from the pool.If MS gives an IP address that is not available in any of the static 
pools defined on the PDIF, then the PDIF disconnects the session.