Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
PDN Gateway Configuration
▀ Configuring the System as a Standalone eGTP P-GW
▄ Cisco ASR 5000 Series Packet Data Network Gateway Administration Guide
OL-22985-01
Required
Information
Information
Description
Interface name
An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and
subnet
subnet
IPv4 or IPv6 addresses assigned to the interface.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port
number
number
The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP
address
address
Used when configuring static IP routes from the interface(s) to a specific network.
Rf Diameter Endpoint Configuration
End point name
An identification string from 1 to 63 characters (alpha and/or numeric) by which the Rf Diameter endpoint
configuration is recognized by the system.
configuration is recognized by the system.
Origin realm
name
name
An identification string between 1 through 127 characters.
The realm is the Diameter identity. The originator’s realm is present in all Diameter messages and is typically
the company or service name.
The realm is the Diameter identity. The originator’s realm is present in all Diameter messages and is typically
the company or service name.
Origin host name
An identification string from 1 to 255 characters (alpha and/or numeric) by which the Rf origin host is
recognized by the system.
recognized by the system.
Origin host
address
address
The IP address of the Rf interface.
Peer name
The Rf endpoint name described above.
Peer realm name
The Rf origin realm name described above.
Peer address and
port number
port number
The IP address and port number of the OFCS.
Route-entry peer
The Rf endpoint name described above.
How This Configuration Works
The following figure and supporting text describe how this configuration with a single source and destination context is
used by the system to process a subscriber call originating from the GTP LTE network.
used by the system to process a subscriber call originating from the GTP LTE network.