Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Software Management Operations
Managing License Keys ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22969-02
Managing License Keys
License keys define capacity limits (number of allowed subscriber sessions) and available features on your system.
Adding new license keys allows you to increase capacity and add new features as your subscriber base grows.
Adding new license keys allows you to increase capacity and add new features as your subscriber base grows.
New System License Keys
New systems are delivered with no license keys installed. In most cases, you receive the license key in electronic format
(usually through email).
(usually through email).
When a system boots with no license key installed a set of default limited session use and feature licenses is installed.
The following Exec Mode command lists the license information:
The following Exec Mode command lists the license information:
Important:
With no license key installed, the session use licenses for PDSN, HA, GGSN, and L2TP LNS are
limited to 10,000 sessions.
SPCs/SMCs are shipped with a CompactFlash card installed. A single license key is generated using the serial numbers
from the CompactFlash cards. If two SPCs/SMCs are installed, the license key is generated from the serial numbers of
both CompactFlash cards. This allows the license to be distributed across both SPCs/SMCs, ensuring that licensed
capacity and features remain available during a switchover event.
from the CompactFlash cards. If two SPCs/SMCs are installed, the license key is generated from the serial numbers of
both CompactFlash cards. This allows the license to be distributed across both SPCs/SMCs, ensuring that licensed
capacity and features remain available during a switchover event.
Installing New License Keys
Use the instructions below to install a new license key.
Cutting and Pasting the Key
If you have a copy of the license, use the following configuration to cut and paste just the licence key part:
Step 1
From the Exec mode, enter the following: