Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Troubleshooting the System
▀ Detecting Faulty Hardware Using Component LEDs
▄ Cisco ASR 5000 Series System Administration Guide
OL-22969-02
Table 36. SPIO RUN/FAIL LED States
Color
Description
Troubleshooting
Green
Card powered with no
errors detected
errors detected
None needed.
Red
Card powered with
error(s) detected
error(s) detected
Errors were detected during the POSTs. It is likely that the errors were logged to the system's
command line interface during the boot process.
Refer to the Monitoring the System chapter of this reference for information on determining the
status of system hardware components.
command line interface during the boot process.
Refer to the Monitoring the System chapter of this reference for information on determining the
status of system hardware components.
None
Card is not receiving
power
power
Verify that the POWER LEDs on the PFUs are green. If they are not, refer to the
Checking the LED on the PFU(s) section in this chapter for troubleshooting
information.
Checking the LED on the PFU(s) section in this chapter for troubleshooting
information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in the Hardware
Installation and Administration Guide.
Installation and Administration Guide.
If all of the above suggestions have been verified, it is possible that the SPIO is not
functional. Please contact your service representative.
functional. Please contact your service representative.
SPIO Active LED States
The Active LED on the SPIO indicates that the software is loaded on the card and that the card is ready for operation.
For the SPIO installed in chassis slot 24, this LED should be green for normal operation. For the SPIO installed in slot
25, this LED should be off for normal operation.
For the SPIO installed in chassis slot 24, this LED should be green for normal operation. For the SPIO installed in slot
25, this LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 37.
SPIO Active LED States
Color
Description
Troubleshooting
Green
Card is active
None needed for SPIO in slot 24. If green for SPIO in slot 25, then verify that SPIO in slot
24 is installed properly according to the instructions in this document.
24 is installed properly according to the instructions in this document.
None
Card is not receiving
power OR Card in
Standby Mode
power OR Card in
Standby Mode
Verify that the RUN/FAIL LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to the SPIO RUN/FAIL LED States
section of this chapter for troubleshooting information.
POST test results are positive. If it is off, refer to the SPIO RUN/FAIL LED States
section of this chapter for troubleshooting information.
Check the state of the Standby LED. If it is green, the card is in standby mode. This
is normal for the SPIO in slot 25 since the chassis automatically places the card
into standby mode at boot up.
is normal for the SPIO in slot 25 since the chassis automatically places the card
into standby mode at boot up.