Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Troubleshooting the System
▀ Detecting Faulty Hardware Using Component LEDs
▄ Cisco ASR 5000 Series System Administration Guide
OL-22969-02
Color
Description
Troubleshooting
Red
Card powered with
error(s) detected
error(s) detected
Errors were detected during the POSTs. It is likely that the errors were logged to the system's
command line interface during the boot process.
Refer to the Monitoring the System chapter of this reference for information on determining the
status of system hardware components.
command line interface during the boot process.
Refer to the Monitoring the System chapter of this reference for information on determining the
status of system hardware components.
None
Card powered with
error(s) detected
error(s) detected
Verify that the POWER LEDs on the PFUs are green. If they are not, refer to the
Checking the LED on the PFU(s) section in this chapter for troubleshooting
information.
Checking the LED on the PFU(s) section in this chapter for troubleshooting
information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in the Hardware
Installation and Administration Guide.
Installation and Administration Guide.
If all of the above suggestions have been verified, it is possible that the SPIO is not
functional. Please contact your service representative.
functional. Please contact your service representative.
RCC Active LED States
The Active LED on the RCC indicates that the card is being used. For normal operation, this LED should be off on both
RCCs.
RCCs.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 47.
RCC Active LED States
Color
Description
Troubleshooting
Green
Card is active
The RCC is actively routing traffic from a line card installed behind a PAC/PSC that has
failed to a redundant PAC/PSC.
The RCC installed in chassis slot 40 processes traffic for the line cards in chassis slots 17
through 23 and 26 through 32. The RCC installed in chassis slot 41 processes traffic for the
line cards in slots 33 through 39 and 42 through 48.
Refer to either the Checking the LEDs on the PAC(s) or Checking the LEDs on the PSC(s)
section of this chapter to determine which PAC/PSC has failed.
failed to a redundant PAC/PSC.
The RCC installed in chassis slot 40 processes traffic for the line cards in chassis slots 17
through 23 and 26 through 32. The RCC installed in chassis slot 41 processes traffic for the
line cards in slots 33 through 39 and 42 through 48.
Refer to either the Checking the LEDs on the PAC(s) or Checking the LEDs on the PSC(s)
section of this chapter to determine which PAC/PSC has failed.
None
Card is not receiving
power OR Card in
Standby Mode
power OR Card in
Standby Mode
Verify that the RUN/FAIL LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to the RCC RUN/FAIL LED States
section of this chapter for troubleshooting information.
POST test results are positive. If it is off, refer to the RCC RUN/FAIL LED States
section of this chapter for troubleshooting information.
Check the state of the Standby LED. If it is green, the card is in standby mode. This
is the normal operating mode.
is the normal operating mode.