Cisco Cisco Network Assistant Version 3.0
16
Release Notes for Cisco Network Assistant 2.1 and Later
OL-7539-03
Open Caveats
•
CSCeg56906
When you create an enable password through Network Assistant, you create an enable secret
(encrypted) password. Therefore, no entry for the password appears on the Enable Password tab of
the Users and Passwords window.
(encrypted) password. Therefore, no entry for the password appears on the Enable Password tab of
the Users and Passwords window.
If you do not want to create an encrypted password, the workaround is to use the CLI to create a
nonencrypted password. Network Assistant will prompt users for this password when they connect,
even though the password does not appear on the Enable Password tab.
nonencrypted password. Network Assistant will prompt users for this password when they connect,
even though the password does not appear on the Enable Password tab.
•
CSCeh56944
Access points and routers are not supported in the Front Panel view, but sometimes the check boxes
for these devices are checked, even if they are grayed out.
for these devices are checked, even if they are grayed out.
There is no workaround.
•
CSCeh59451
Even if you see the message Port security is only supported on static access
interfaces
interfaces
, it is also supported on ISL trunk ports and 802.1Q trunk ports if these ports are
supported by the Cisco IOS image.
The Port Security window lists all the ports that are eligible for port security. If a port is not listed,
configure the port as necessary through the VLAN window, and return to Port Security window to
configure the port security settings.
configure the port as necessary through the VLAN window, and return to Port Security window to
configure the port security settings.
•
CSCeh61146
If the window for the Cluster Conversion window is covered by other windows, launching it again
does not bring it to the front.
does not bring it to the front.
Go to the Window menu and select it.
•
CSCeh61167
A community member might become unmanageable if its Cisco IOS image is downgraded from a
cryptographic image to a noncryptographic image.
cryptographic image to a noncryptographic image.
Use the Modify Community window to remove the device from the community, and then add it to
the community again.
the community again.
•
CSCeh61556
If you cancel the authentication window for every device in a community, the community is
unmanageable. You cannot reconnect to it or connect to another community.
unmanageable. You cannot reconnect to it or connect to another community.
Launch Network Assistant again.
•
CSCeh65534
The port colors on the Front Panel view are inaccurate when ports on Catalyst 2950, 3550, and 3750
switches are set to half duplex.
switches are set to half duplex.
Open the Port Settings window to confirm that the port settings are correct.
•
CSCeh71330
Network Assistant cannot change the default HTTP port number from 80 to another value on a
switch that runs Cisco IOS 12.2(20)EWA.
switch that runs Cisco IOS 12.2(20)EWA.
The workaround is to change the port number through the CLI with the command ip http port
port#. Network Assistant continues to show the port number as 80.
port#. Network Assistant continues to show the port number as 80.