Cisco Cisco 526 Wireless Express Mobility Controller
3
Release Notes for Cisco 526 Wireless Express Mobility Controller and Cisco 521 Wireless Express Lightweight Access Point, 4.1.154.23
OL-13554-01
Installation Notes
Installation Notes
This section contains important information for installing 526 controllers and 521 access points.
Warnings
This section provides safety warnings for the 526 controller and 521 access point. For translations of
these safety warnings, refer to the translated safety warnings document at this URL:
these safety warnings, refer to the translated safety warnings document at this URL:
Warning
This warning means danger. You are in a situation that could cause bodily injury. Before you work on
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Statement 1071
any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Statement 1071
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer’s instructions. Statement 1015
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer’s instructions. Statement 1015
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Statement 1040
These warnings apply to the 521 access point:
Warning
This product must be connected to a Power-over-Ethernet (PoE) IEEE 802.3af compliant power source
or an IEC60950 compliant limited power source. Statement 353
or an IEC60950 compliant limited power source. Statement 353
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located a
minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive
environment unless the device has been modified to be especially qualified for such use. Statement
245B
environment unless the device has been modified to be especially qualified for such use. Statement
245B
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Statement 1001