Cisco Cisco Packet Data Gateway (PDG) Ratgeber Für Administratoren

System Interfaces and Ports

▀ Frame Relay Interfaces and Ports

▄ Cisco ASR 5000 System Administration Guide

106

Verifying the Frame Relay Interface Configuration and Status

Several commands generate display outputs that provide information about the Frame Relay card, port, DLCI and link
configurations. The most commonly used commands are illustrated below. All of these commands are issued from the
Exec mode.

Display Port and DLCI Configuration Details

[local]host_name# show port info 27/1
Port: 27/1
  Port Type   : STM1/OC3 Channelized
  Description   : (None Set)
  Controlled By Card     : 11 (Packet Services Card)
  Redundancy Mode   : Port Mode
  Framing Mode : SDH
  Redundant With : Not Redundant
  Preferred Port : Non-Revertive
  Physical ifIndex : 453050368
  Administrative State : Disabled
  Link State : Unknown
  Line Timing   : Yes
  SFP Module : Not Present
  Path 1 e1 1   : tu12-au3 1/1 crc4 bit-async
  Timeslots   : 12-14
  Frame Relay Intf Typ : DCE
  Frame Relay LMI Type : Q933A
  Frame Relay LMI n391 : 6
  Frame Relay LMI n392 : 2
  Frame Relay LMI n393 : 2
  Frame Relay LMI t391 : 10
  Frame Relay LMI t392 : 15
      Frame Relay DLCI 243
  Logical ifIndex   : 453050369
  Admin State   : Disabled
  Operational State   : Down, Standby
  Shaping   : WFQ: Weight 1
  Number of DLCI : 1
  Reserved Bandwidth : 0 of 192000 bits/sec
  Path 1 e1 2   : Unused
  Number of DLCI : 1

Display Port and DLCI Configuration and Status

The following display is only a partial output of the show command to illustrate the channelized port and DLCIs.

[local]host_name# show port table
Port  Type   Admin Oper  Link  State Redundant With
----  ----------------------  --------  ----  ----  --------  --------------
27/1  STM1/OC3 Channelized   Enabled   -   Up   -   None
  FR DLCI 1  1  1  52 Enabled Up   - Active -
  FR DLCI 1  2  1  53 Enabled Down  - Active -